This paper deals with a study of the biosorption of UO22+ ions on two green algae: Chlorella vulgaris and Dunaliella salina. By investigating the retention degree versus contact time from Langmuir and Freundlich biosorption isotherms, kinetic investigations and FTIR spectra it was found that the biosorption process was greater for Chlorella vulgaris than for Dunaliella salina. A new kinetics method is proposed to establish the reaction order concerning the biosorption process of uranyl ions on these biomasses. [...]
Abstract In this investigation a waste biological material, soybean meal, was applied as a biosorbent for heavy metal ions (CrIII). The diffusive Webber-Morris model and the pseudo-II-order model suitably described the kinetics of CrIII ions binding on soybean meal. The Langmuir-Freundlich equation was valid for the description of the isotherm. Inductively coupled plasma optical emission spectroscopy (ICP-OES), FTIR and scanning electron microscopy with an energy dispersive X-ray analytical system (SEM-EDX) were used in order to identify the mechanism of the metal ions binding. The analysis of the composition of the enriched soybean meal confirmed the contribution of ion exchange in the biosorption process. Three-variable-three-level Box-Behnken design was used to determine the optimal conditions for biosorption of CrIII on soybean meal. The optimal conditions for predicted maximum Cr3+ uptake (61.07 mg g−1) by soybean meal were estimated by Matlab and established as temperature of 38.04°C, initial metal concentration 500 mg L−1 and biosorbent dosage 1 g L−1. Graphical abstract [...]
Abstract Heavy metals, derived from industrial wastewater discharge, present a serious threat to human health and to natural water. Biosorption is regarded as a cost-effective biotechnology for the treatment of high volume and low concentration wastewaters containing heavy metal(s) in the order of 1 to 100 mg L−1. Among the biomaterials for heavy metal removal which have been researched during the past decades is the Streptomyces species, a by-product of an industrial antibiotic fermentation process. This paper describes the hazards posed by heavy metals effluents on the environment and use of various Streptomyces species to remove heavy metals from aqueous solution. Characterization of Streptomyces species, factors affecting biosorption, biosorption isotherms and biosorption kinetics is discussed. Graphical abstract [...]
Polyvinyl alcohol (PVA) and tetraethoxysilane (TEOS) hybrid materials were prepared by sol-gel methods and tested as matrices for immobilization of Trichosporon cutaneum R57, capable of removing cadmium and copper ions from aqueous solutions. A kinetic model was applied and the effects of matrix TEOS content on the copper and cadmium uptake equilibria and rate constants were investigated. [...]
This paper describes the potential application of a freely suspended cyanobacterial biomass of Microcystis aeruginosa as a sorption material for toxic metals, cadmium (Cd) and lead (Pb) from aqueous solutions. In order to identify the most suitable conditions for removal of these elements (concentration range: 1–20 mg L−1), the laboratory experiments were carried out during different incubation times (1–48 h) and under various temperatures (10–40°C), pH (5–9) and with or without light irradiance. Competitive biosorption of Cd and Pb was also investigated. We found that M. aeruginosa demonstrates high efficiency in removing both of the studied metals from aqueous solutions. Sorption of Pb occurred, however, more rapidly and effectively, and was less disturbed by changes in physico-chemical conditions. Under pH=7, 25°C and light, the removal rates after 3 h and 6 h of incubation, were 90–100% for Pb and 79.5–100% for Cd, respectively. The co-occurrence of the metals decreased the rate of metal biosorption. Pb was sequestered preferentially over Cd. From the results we conclude that freely suspended M. aeruginosa can constitute a promising low-cost, easy-producible biosorbent material for toxic metals in contaminated wastewater.
The feasibility of the application of various eluents for recovery of lead and cadmium from Saccharomyces biomass has been investigated. Desorbing agents such as HCl, HNO3, H2SO4, Na2SO4, Na2CO3, EDTA and NaOH at concentrations of 0.05–0.5 M were used. The possibility of re-using of S. pastorianus for cadmium removal was assessed. Among the desorbing agents EDTA and mineral acids were the most effective, as approximately 85% of lead and cadmium could be recovered. However, when HNO3 and EDTA were used as desorbing agents, a dramatic loss in the cadmium adsorption by the biomass in the next cycles was observed.
Properties of metal solution, environmental conditions and the type of biomaterials (microorganism genus, species or even strain) influence the mechanism of metal biosorption and consequently metal adsorption capacity, affinity and specificity. Cell surface properties determine the metal-microorganism interactions to a large extent. In this work the relationship between yeast surface properties and yeast’s ability to bind cadmium, lead and copper was studied. Surface charge and hydrophobicity before and after biosorption were determined using dye retention and solvent partition assays, respectively. There were differences in the surface charge and relative hydrophobicity among different yeast strains. A higher metal adsorption capacity for more negatively charged yeast cells was observed. Biosorption of heavy metals resulted in modifications to the surface charge and hydrophobicity of yeast cells. However, there were not statistically significant changes in the yeast surface charge and hydrophobicity after binding of heavy metals depending on the nature of the metal, initial metal concentration and solution pH.
The biosorption Brilliant Red HE-3B reactive dye by nonliving biomass, Saccharomyces cerevisiae, in batch procedure was investigated. Equilibrium experimental data were analyzed using Freundlich, Langmuir and Dubinin - Radushkevich isotherm models and obtained capacity about 104.167 mg g−1 at 20°C. The batch biosorption process followed the pseudo-second order kinetic model. The multi-linearity of the Weber-Morris plot suggests the presence of two main steps influencing the biosorption process: the intraparticle diffusion (pore diffusion), and the external mass transfer (film diffusion). The results obtained in batch experiments revealed that the biosorption of reactive dye by biomass is an endothermic physical-chemical process occurring mainly by electrostatic interaction between the positive charged surface of the biomass and the anionic dye molecules. The biosorption mechanism was confirmed by FT-IR spectroscopy and microscopy analysis [...]
This study aims to explore the efficiency of an agro waste material for the remediation of Pb(II) contaminated water. A factorial design approach is adopted to optimize removal efficiency and to study the interaction between effective variables. A face-centered Draper-Lin composite design predicted 100% removal efficiency at optimum variables; pH 8, initial concentration of Pb(II) ion 12mg/L, sorbent dose 200mg and agitation time 110 min. Regration coefficient (R2 = 99.9%) of a plot of the predicted versus the observed values and p value (>0.05) confirms the applicability of the predicted model. Langmuir and Dubinin-Radushkevich (D-R) isotherm models were applicable to sorption data with the Langmuir sorption capacity of 21.61±0.78 mg/g. The energy of sorption was found to be 13.62±0.32 kJ/mol expected for ion-exchange or chemisorption nature of sorption process. Characterization of Grewia seed suggested a possible contribution of carboxyl and hydroxyl groups in the process of biosorption. The present study shows that Grewia seeds can be used effectively for the remediation of Pb(II) contaminated water.
JavaScript is turned off in your web browser. Turn it on to take full advantage of this site, then refresh the page.