PL EN


Preferences help
enabled [disable] Abstract
Number of results
2017 | 131 | 5 | 1225-1227
Article title

Scaling-Based Analysis and Modelling of Power Losses in Amorphous and Nanocrystalline Alloys

Authors
Content
Title variants
Languages of publication
EN
Abstracts
EN
The paper presents the scaling-based approach to analysis and modelling of power losses in Fe-based amorphous and nanocrystalline alloys. Production technology and properties of these alloys are briefly presented. For each sample, a family of measured loss curves are collapsed onto a single one using appropriate estimated scaling parameters. An interpretation of the fractional exponent is discussed. The scaling analysis is used in the modelling of power losses for the considered alloys. The results of power loss modelling and obtained errors are presented.
Keywords
EN
Contributors
author
  • Częstochowa University of Technology, Faculty of Electrical Engineering, al. Armii Krajowej 17, 42-200 Częstochowa, Poland
References
  • [1] G. Bertotti, J. Magn. Magn. Mater. 41, 253 (1984), doi: 10.1016/0304-8853(84)90192-6
  • [2] G. Bertotti, IEEE Trans. Magn. 24, 621 (1988), doi: 10.1109/20.43994
  • [3] G. Bertotti, Hysteresis in Magnetism, Academic Press, San Diego 1998
  • [4] B.D. Cullity, C.D. Graham, Introduction to Magnetic Materials, 2nd ed., Wiley-IEEE Press, Hoboken 2009, doi: 10.1002/9780470386323
  • [5] J. Barranger, Hysteresis and Eddy-Current Losses of a Transformer Lamination Viewed as an Application of the Poynting Theorem, NASA Technical Note TN D-3114, Washington D.C. 1965
  • [6] K. Chwastek, Philos. Mag. Lett. 90, 809 (2010), doi: 10.1080/09500839.2010.508442
  • [7] S. Mulder, Power Conv. Intellig. Motion 21, 22 (1995)
  • [8] K. Venkatachalam, C.R. Sullivan, T. Abdallah, H. Tacca, in: Proc. IEEE Workshop on Computers in Power Electronics, Puerto Rico, 2002, p. 36, doi: 10.1109/CIPE.2002.1196712
  • [9] K. Sokalski, J. Szczygłowski, W. Wilczyński, Int. J. Condens. Matter 12, 1 (2014)
  • [10] Finemet. Square loop cores, Technical Bulletin, Metglas, Inc. http://electronix.ru/forum/index.php?act=attach&type=post&id=60907
  • [11] K. Sokalski, J. Szczyglowski, M. Najgebauer, W. Wilczynski, COMPEL 26, 640 (2007), doi: 10.1108/03321640710751118
  • [12] M. Najgebauer, Prz. Elektrotechn. 84, 213 (2008)
  • [13] B. Widom, J. Chem. Phys. 43, 3898 (1965), doi: 10.1063/1.1696618
  • [14] H.E. Stanley, Rev. Mod. Phys. 71, S358 (1999), doi: 10.1103/RevModPhys.71.S358
  • [15] M. Najgebauer, Acta Phys. Pol. A 128, 107 (2015), doi: 10.12693/APhysPolA.128.107
  • [16] R. Gozdur, M. Najgebauer, J. Electr. Eng. 66, 37 (2015)
  • [17] G. Herzer, Scr. Metall. Mater. 33, 1741 (1995), doi: 10.1016/0956-716X(95)00397-E
  • [18] M.E. McHenry, M.A. Williard, D.E. Laughlin, Prog. Mater. Sci. 44, 291 (1999), doi: 10.1016/S0079-6425(99)00002-X
  • [19] R. Hasegawa, J. Magn. Magn. Mater. 215-216, 240 (2000), doi: 10.1016/S0304-8853(00)00126-8
  • [20] R. Hasegawa, J. Magn. Magn. Mater. 304, 187 (2006), doi: 10.1016/j.jmmm.2006.02.119
  • [21] M. Najgebauer, J. Szczygłowski, Prz. Elektrotechn. 84, 136 (2008)
Document Type
Publication order reference
Identifiers
YADDA identifier
bwmeta1.element.bwnjournal-article-appv131n507kz
JavaScript is turned off in your web browser. Turn it on to take full advantage of this site, then refresh the page.