PL EN


Preferences help
enabled [disable] Abstract
Number of results
2017 | 131 | 4 | 1087-1089
Article title

Magneto-Structural Anisotropy of Hard Milled Surface

Content
Title variants
Languages of publication
EN
Abstracts
EN
This paper deals with investigation of hard milled surface as a surface undergoing severe plastic deformation at elevated temperatures. This surface exhibits quite remarkable magnetic anisotropy (expressed in term of the Barkhausen noise) and differs from ground surfaces. The main reason can be viewed in specific structure and the corresponding domains configuration formed during rapid cooling following after surface heating. Domains are not randomly but preferentially oriented in the direction of the cutting speed at the expense of feed direction. The Barkhausen noise signals (measured in two perpendicular directions such as cutting speed and feed direction) indicate that the mechanism of the Bloch wall motion during cyclic magnetization in hard milled surfaces differ from surfaces produced by grinding cycles or the raw surface after heat treatment.
Keywords
EN
Publisher

Year
Volume
131
Issue
4
Pages
1087-1089
Physical description
Dates
published
2017-04
Contributors
  • Faculty of Mechanical Engineering, University of Žilina, Univerzitná 1, 01026 Žilina, Slovakia
author
  • Faculty of Mechanical Engineering, University of Žilina, Univerzitná 1, 01026 Žilina, Slovakia
author
  • IT4Innovations National Supercomputing Center, VŠB - Technical University of Ostrava, Studentská 6231/1B, 70833 Ostrava, Czech Republic
author
  • Faculty of Mechanical Engineering, University of Žilina, Univerzitná 1, 01026 Žilina, Slovakia
author
  • Institute for Nanomaterials, Technical University in Liberec, Studentská 1402/2, 46117 Liberec, Czech Republic
  • Faculty of Mechanical Engineering, University of Žilina, Univerzitná 1, 01026 Žilina, Slovakia
References
  • [1] V. Moorthy, B.A. Shaw, P. Hopkins J. Magn. Magn. Mater. 299, (2006), doi: 10.1016/j.jmmm.2005.04.028
  • [2] H. Tönshoff, C. Arendt, R. Ben Amor CIRP Annals 49, 547 (2000), doi: 10.1016/S0007-8506(07)63455-6
  • [3] Y.B. Guo, J. Sahni Int. J. Mach. Tool Manufact. 44, 135 (2004), doi: 10.1016/j.ijmachtools. 2003.10.009
  • [4] A. Stupakov, M. Neslušan, O. Perevertov J. Magn. Magn. Mater. 410, 198 (2016), doi: 10.1016/j.jmmm.2016.03.036
  • [5] M. Neslušan, D. Blažek, D. Hrabovský, M. Bukovina Acta Phys. Pol. A 126, 188 (2014), doi: 10.12693/APhysPolA.126.188
  • [6] P. Martínez-Ortiz, J.A. Pérez-Benitez, J.H. Espina-Hernández, F. Caleyo, J.M. Hallen J. Magn. Magn. Mater. 401, 108 (2016), doi: 10.1016/j.jmmm.2015.10.036
Document Type
Publication order reference
Identifiers
YADDA identifier
bwmeta1.element.bwnjournal-article-appv131n4156kz
JavaScript is turned off in your web browser. Turn it on to take full advantage of this site, then refresh the page.