Preferences help
enabled [disable] Abstract
Number of results
2015 | 13 | 1 |
Article title

Influence of electrode material on hydrogen peroxide generation by DC pinhole discharge

Title variants
Languages of publication
In this work, several materials were studied as electrodes in a pinhole configuration of a DC plasma discharge to estimate their effect on the efficiency of the discharge, indicated by hydrogen peroxide production. Detection was carried out using a specific titanium reagent. This was combined with ICP-OES analysis of the final solutions to determine the difference between the amount of electrode material released during the discharge operation and electrolysis experiment carried out under the same conditions. It was found that from seven studied electrode materials, graphite gives the best results, while lower cost aluminum and titanium-zinc still work well. The most unsuitable materials were copper and brass; in these cases, no hydrogen peroxide was detected in the cathode part of the reactor. Results obtained by ICP analysis indicate that even in the case of brass, the absence of hydrogen peroxide is due to the presence of copper in the material. It probably affects both directly the phase of discharge creation and propagation and the decomposition reactions.
Physical description
13 - 5 - 2014
18 - 11 - 2014
20 - 12 - 2013
  • [1] Manojlovic D., Ostojic D.R., Obradovic B.M., Kuraica M.M., Krsmanovic V.D., Puric J., Desalination, 2007, 213, DOI: 10.1016/j.desal.2006.05.059[Crossref]
  • [2] Arjunan K.P., Friedman G., Fridman A., Morss Clyne A., J. R. Soc. Interface, 2011, 66, 9
  • [3] Xu Z., World J. Gastroenterol., 2006, 1, 12
  • [4] Malik M.A., Ahmed M., Naheed R., Ghaffar A., Plasmas Polym., 2003, 8, 4[Crossref]
  • [5] Kim S., Sergiienko R., Shibata E., Hayasaka Y., Nakamura T., Mater. Trans., 2010, 51, 8
  • [6] Stara Z., Krcma F., Slavicek P., Aubrecht V., In: Schmidt J.,Šimek M., Pekárek S., Prukner V., (Eds.), 28th International Conference on Phenomena in Ionized Gases, July 15 – 20 2007, Prague, Czech Republic, Ústav fyziky plazmatu AV ČR, Prague, Czech Republic, 2007, 1082-1085
  • [7] Halamova I., Nikiforov A., Krcma F., Leys Ch., J. Phys.: Conf. Ser., 2014, 516
  • [8] Lukes P., PhD thesis, Institute of Plasma Physics, AS CR, Prague, CZ, 2001
  • [9] Stara Z., Davidova J., Olexova B., Krcma F., Soural I., In: IEEE 35th International Conference on Plasma Science, 15-19 June 2008, Karlsruhe, Germany, IEEE Service Center, Piscataway, NJ, USA, 2008, 193
  • [10] Bruggeman P., Leys Ch., J. Phys. D: Appl. Phys., 2009, 42, 5,DOI: 10.1088/0022-3727/42/5/053001[Crossref]
  • [11] Stara Z., PhD thesis, Brno University of Technology, Brno, CZ, 2006
  • [12] Kozakova Z., Habilitation thesis, Brno University of Technology Brno, CZ, 2011
  • [13] Krcma F., et al., J. Phys.: Conf. Ser., 2010, 207, 1, DOI: 10.1088/1742-6596/207/1/012010[Crossref]
  • [14] Halliwell B., Gutteridge J.M.C., Biochem. J., 1984, 219
  • [15] Hall S.B., Khudaish E.A., Hart A.L., Electrochimica Acta, 1998, 32, 5
  • [16] Nikiforov A.Yu., Leys Ch., Plasma Sources Sci. Technol., 2007, 16
  • [17] Lee B.-H., Kim D.-S., Choi J.-H., J. Electric. Eng. & Technol., 2010, 5, 2
  • [18] De Baerdemaeker F., Šimek M., Leys Ch., Vestraete W., Plasma Chem. Plasma Process, 2007, 27
Document Type
Publication order reference
YADDA identifier
JavaScript is turned off in your web browser. Turn it on to take full advantage of this site, then refresh the page.